Bluelab Dosetronic Solenoid Kit Instrukcja Użytkownika Pobierz pdf (Strona 33)

Version S1.3 : 260511

Bluelab Dosetronic Solenoid Kit

Bluelab Corporation Limited

Preparing System to Run

Setting up the Dosetronic system involves setting the Control direction, Required values and On and Off times. These settings

can be edited by scrolling through the Mode menu on the Dosetronic Control panel. The steps for this are outlined in chapter 3.

4.1 Prepare the Dosetronic system to run

Step 1. Flush out PVC shavings and glue residue

If your system has been installed it is important to ﬂ ush out PVC shavings

(swarf) and any glue residue before growing commences. To do this ﬁ ll your

nutrient tank and then ﬂ ush all water from your system.

Step 2. Fill tanks A, B and pH with stock solutions.

Step 3. Manually prime tank

In order for the Dosetronic to adjust your main nutrient tank to your

programmed required values you need to manually prime the tank with nutrient.

By Raising the EC to above 0.1 the Dosetronic will be able to start dosing.

Dosing stops at 0.0 - 0.1EC to prevent dosing if the probe is out of solution.

(Instructions are on the following page)

Step 4. Check readings/settings

Make sure all your settings are working and that your readings are within your

required range by scrolling through the mode menu.

Step 5. Plug Solenoids into mains power.

Outlined on page 10

Step 6. Plug heater/cooler into mains power.

Outlined on page 12

Step 7. Complete checklist opposite.

Step 8. Select Control in mode menu. System should be running.

Monitor system regularly for 24 hours to check On & Off times are correct and

control is stable.

Note: The pH probe must be

kept wet at all times. Ensure the

nutrient probe is clean and the pH

probe calibrated before starting

this task.

Nutrient tank set-up

Stock solution

Dosing system

Control case

Probe connections

Heater/Cooler

Alarm Box (optional)

Main Power

Units

Control direction

Off Times

On Times

pH calibration

Check dosing

Final Checklist

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 44 45

Komentarze do niniejszej Instrukcji

Brak uwag

Bluelab Dosetronic Solenoid Kit Instrukcja Użytkownika Strona 33

Komentarze do niniejszej Instrukcji